Grizzly G0602 Lathe User Manual


  Open as PDF
of 64
 
BdYZa<%+%'B[\#H^cXZ.$%-
"',"
6 YZVY XZciZg XVc WZ jhZY ^c i]Z iV^ahidX` VcY
aVi]Zhe^cYaZidhjeedgildg`e^ZXZh#L]ZcjhZY
^ci]ZiV^ahidX`!bV`ZhjgZid`ZZei]ZYZVYXZciZg
i^eVcYldg`e^ZXZajWg^XViZYidegZkZcii^e\Vaa"
^c\#
To install a dead or live center:
1. ;ZZY i]Z fj^aa dji VWdji & VcY ^chZgi i]Z
YZVYXZciZgFigure 23# I]ZbVi^c\iVeZgh
egdk^YZi]ZadX`^c\[^i#
Figure 24.;VXZeaViZVcYYZVYXZciZghZije#
Centers
To install an MT#4 dead center in the spindle:
1. 9>H8DCC:8IEDL:GIDI=:A6I=:
2. GZbdkZi]ZX]jX`[gdbi]Zhe^cYaZ#
3. >chiVaai]ZBI)YZVYXZciZg^ci]Zhe^cYaZ#
4. 6iiVX] i]Z [VXZeaViZ id i]Z he^cYaZ! hZZ
Figure24#
Note: When using the dead center in the
spindle, use a lathe dog so that your part will
rotate with the faceplate and not spin on the
dead center tip.
Figure 23.>chZgi^c\YZVYXZciZg#
2. BdkZ i]Z iV^ahidX` ^cid edh^i^dc VcY adX` ^c
eaVXZ#
Note: Make sure there is a center drilled hole
in the end of the workpiece for the dead cen-
ter.
3. ;ZZYi]Zfj^aa^cidi]Zldg`e^ZXZ#
4. AdX`i]Zfj^aa^cideaVXZdcXZi]ZYZVYXZciZg
VcYi]Z ldg`e^ZXZgdiViZid\Zi]Zg# I]Zfj^aa
bVncZZYidWZVY_jhiZYYjg^c\deZgVi^dc#
5. IdgZbdkZ i]ZYZVY XZciZg!gZigVXii]Z fj^aa
jci^ai]ZYZVYXZciZgedeh[gZZ#
Failure to keep dead center point well
lubricated will gall the dead center and
workpiece.
 previous next