Grizzly G0602 Lathe User Manual


  Open as PDF
of 64
 
BdYZa<%+%'B[\#H^cXZ.$%-
"(*"
Figure 37.BZig^Xi]gZVY^c\hZije#
BZig^XI]gZVY8]Vgi
= 0.45mm
b
a
JhZi]ZhZhiZehidaZVgc]dlidhZijendjgaVi]Z
[dg bZig^X i]gZVY^c\# I]Z ZmVbeaZ ^c Figure 37
h]dlhaVi]ZhZije[dgXjii^c\VbZig^Xi]gZVYe^iX]
d[%#)*bb#
To setup for metric threading:
1. 9>H8DCC:8II=:A6I=:;GDB
EDL:G
2. Ijgci]Z[ZZYY^Vahidi]ZcjbZgVaVcYaZiiZg
^cY^XViZYWni]ZX]Vgi^c Figure 37#
Note:You may have to rock the chuck by
hand slightly to get the gearbox gears to
engage one another.
3. Jh^c\ i]Z X]Vgi ^c Figure 36! \Vi]Zg i]Z
gZfj^gZYX]Vc\Z\ZVgh#
4. DeZc i]Z h^YZ XdkZg VcY jhZ V +bb ]Zm
lgZcX] id addhZc i]Z aVh] VY_jhiZg Figure
34VcYhl^c\i]ZX]Vc\Z\ZVgVhhZbWandji
d[i]ZlVn#
Metric Threads
5. GZbdkZ i]Zhe^cYaZ :"Xa^eh VcYXVe hXgZl!
ajWg^XViZ!VcYhlVedjii]ZX]Vc\Z\ZVgh^c
i]ZdgYZgh]dlcdci]ZX]Vgi^cFigure 34.
Note:All change gears are stamped with the
number of teeth they have.
6. BdkZ i]Z aVh] VY_jhiZg hd i]Z \ZVg WVX`"
aVh]^hWZilZZc%#%%(id%#%%-!i^\]iZci]Z
aVh] VY_jhiZgXVe hXgZl!VcY XadhZi]Z h^YZ
XdkZg#
7. Jh^c\V*bb]ZmlgZcX]!bV`ZhjgZi]ZXVg"
g^V\ZadX`^haddhZFigure 33#
8. I]ZaVi]Z^hcdlhZije[dgi]gZVY^c\#
Note:Since this lathe has an Inch lead screw, do
not use the thread dial when cutting metric threads.
Instead you must leave the half nut engaged until
the threading operation is totally complete.
During threading keep your hand on the
half-nut lever ready to disengage the half
nut to avoid potential carriage/chuck crash.
 previous next