Filter
Top Products
-46-
G0633/G0634 Jointer/Planer Combo Machine
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Tools Needed Qty
Straightedge ...................................................... 1
Phillips Screwdriver ...........................................
1
To calibrate the depth scale:
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2. Set the outfeed table height as described in
the Setting Outfeed Table Height instruc-
tions on
Page 18.
3. Use the straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in
Figure 65.
Calibrating Depth
Scale
Pulley Alignment
Figure 67. Fence and V-belt cover removed.
2. Place a 2" C-clamp on each pulley so the
adjustment shaft faces out, place a straight
-
edge on the clamps, as shown in
Figure 68,
and visually check pulley alignment.
Figure 68. Checking belt alignment.
4. Using a screwdriver, adjust the scale pointer
to zero (
Figure 66).
Figure 65. Infeed table even with outfeed table.
Figure 66. Depth scale adjusted to “0” position.
Tools Needed: Qty
Straightedge ...................................................... 1
Hex Wrench
3mm .............................................. 1
C-Clamps ........................................................... 2
Proper pulley alignment (see
Figure 68) prevents
premature belt wear.
The pulleys are properly
aligned when they are parallel and in the same
plane as each other.
To align the pulleys:
1. Remove the fence assembly, fence bracket,
and the V-belt cover (
Figure 67).