Filter
Top Products
-15-
G0668 20" Vertical Metal-Cutting Bandsaw
10. Press the Emergency Stop button to stop the
machine.
11. WITHOUT resetting the switch, press the
Start button. The machine should not start.
— If the machine does not start, the Emergency
Stop button safety feature is working cor
-
rectly.
— If the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. The Emergency
Stop button safety feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
12. Reset the Emergency Stop button by twisting
it clockwise until it pops out.
13. Turn the Power Switch key to the OFF posi-
tion—the Power Lamp should go out.
For your convenience, the adjustments listed
below have been performed at the factory.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in the SERVICE section starting on
Page 34
.
Factory adjustments that should be verified:
1. Lower wheel pulley alignment (refer to Page
36).
2. Tensioning V-belts (refer to Page 36).
Recommended
Adjustments
NOTICE
After the first 16 hours of operation, new
V-belts will stretch and seat farther into the
pulleys. To avoid slippage, re-tension new
V-belts after this period.
3. Wheel alignment (refer to Page 38).
4. Table alignment relative to the blade (refer to
Page 40).
14. Press the Start button.
— If the machine does not start, the Power
Switch safety feature is working correctly.
— If the machine does start with the Power
Switch key turned to the OFF position,
immediately disconnect power to the
machine. The Power Switch safety feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
If all of the Test Run procedures were successful,
your bandsaw is ready for operation.
The Power Switch is intended to prevent
unauthorized use of this machine. The Power
Switch does not disconnect the bandsaw
from power. To avoid the risk of serious per
-
sonal injury, you MUST physically disconnect
the bandsaw from the power source before
performing adjustments, maintenance, or
service to this machine.