Filter
Top Products
Model G0790 (Mfd. Since 9/15)
-15-
Dust Collection
To connect a dust collection hose:
1. If installed, remove dust bag and clamp from
dust port (see Figure 11).
2. Fit 2
1
⁄2" dust hose over dust port and secure
with hose clamp.
3. Tug hose to make sure it does not come
off. Note: A tight fit is necessary for proper
performance.
Recommended CFM at Dust Port: 250 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
6. Position (2) cord wraps over pre-drilled holes
in planer cabinet (see Figure 9), and secure
with (4) M4-.7 x 10 Phillips head screws.
7. Slide dust port onto fan housing (see Figure
10) and tighten pre-installed button head cap
screw with 4mm hex wrench.
Figure 10. Dust port installed on fan housing.
Dust Port
Fan
Housing
Figure 9. Cord wraps installed with #2 Phillips
head screwdriver.
x 4
8. Slide dust hose clamp over dust bag, insert
bag and clamp over dust port (see Figure
11), and secure with handle.
Figure 11. Dust bag installed on port and
secured by clamp.
Dust Bag
Clamp
Dust Port