Filter
Top Products
-16-
Model G0790 (Mfd. Since 9/15)
Te s t Ru n
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Make sure you have read safety instructions
at beginning of manual and that machine is
set up properly.
2. Make sure all tools and objects used during
setup are cleared away from machine.
3. Connect machine to power source.
4. Turn machine ON, verify motor operation,
then turn machine OFF. Motor should run
smoothly and without unusual problems or
noises.
5. Remove switch disabling key, as shown in
Figure 12.
6. Try to start machine with paddle switch.
— If machine does not start, switch disabling
feature is working as designed.
— If machine starts, immediately stop
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Figure 12. Removing key from paddle switch to
disable switch and prevent unauthorized use.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.