Filter
Top Products
-4-
Model G0790 (Mfd. Since 9/15)
Controls &
Components
Refer to Figures 1–2 and the following descrip-
tions to become familiar with the basic controls of
this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
A. ON/OFF Switch: Turns motor ON when
flipped up; turns motor OFF when pressed
down.
B. ON/OFF Switch Disabling Key: Disables
switch when yellow key is removed so motor
cannot start.
C. Reset Button: Allows machine to be restart-
ed after thermal overload protection has
tripped the motor. To reset the button, place
ON/OFF switch in OFF position, wait a few
minutes for motor to cool, then press reset
button. If button does not stay depressed,
allow motor to cool off longer, then try again.
D. Cutterhead Elevation Crank: Raises and
lowers cutterhead. Turning clockwise raises
cutterhead; turning counterclockwise lowers
it.
E. Cutterhead Elevation Scale: Shows the
elevation of the cutterhead above the table.
The measurement indicated by the red arrow
is the effective thickness of the board after
planing.
F. Return Rollers: For assistant to slide
workpiece back to operator following planing
operation.
Figure 1. ON/OFF switch and reset button.
A
C
B
Figure 2. Elevation controls and return rollers.
DF
E