Filter
Top Products
-20- G1022 Series Contractor Saws
3. Set the motor on end and slip the pulley
guard bracket between the base of the motor
and the motor plate. Tighten one of the four
mounting bolts. Leave the other three loose
as shown in Figure 15.
Figure 15. Installing pulley guard.
Figure 16. Installing the motor mount bracket.
4. Locate the motor mount bracket. Loosen the
setscrew that holds the motor pivot rod in
place and remove the rod. Line up the hole
in the motor bracket with the hole in the
motor plate and insert the motor pivot rod
making sure the groove in the rod lines up
with the setscrew in the mount bracket as
shown in Figure 16. Tighten the setscrew.
Figure 17. Attaching motor to linking bars.
5. Turn the arbor tilting handwheel until the
arbor is set to 0°. Slide the motor assembly
onto the linking bars through the holes in the
motor bracket. Line up the setscrews with
the grooves on the linking bars and tighten
as shown in Figure 17.
Figure 18. Attaching the V-belt to the motor.
6. Lift the motor up and slip the V-belt over the
grooves in the pulleys. Slowly release the
motor, allowing its weight to add tension to
the V-Belt as shown in Figure 18.