Filter
Top Products
-42- G1022 Series Contractor Saws
SECTION 7: MAINTENANCE
Disconnect power to the
machine when perform-
ing any maintenance or
repairs. Failure to do this
may result in serious
personal injury.
!
The sealed ball bearings in the motor and
throughout the Model G1022 Series require no
further lubrication during their lifetime. When they
do wear out, replacements can be obtained
through the Grizzly Parts Department. Lubricate
the areas indicated below every 12 months.
1. Blade angling trunnions. These should be
lubricated with 6 or 7 drops of light machine
oil.
2. Blade height trunnion. This should also be
lubricated with 6 or 7 drops of light machine
oil.
3. The two (2) worm gears should be lubricat-
ed with an automotive wheel bearing grease.
Lubrication
General
Tables
Keep clothing rolled
up and out of the way
of machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
V-Belt
Inspect regularly for tension and wear. Check pul-
leys to ensure that they are properly aligned. See
pulley/V-belt sections for proper tension and pul-
ley alignment procedures.
Regular periodic maintenance on your Model
G1022 Series will ensure its optimum perfor-
mance. Make a habit of inspecting your machine
each time you use it. Check for the following con-
ditions and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
6. Inspect blades for damage.
7. Guard alignment and operation.
Tables can be kept rust-free with regular applica-
tions of products like Boeshield
®
T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit™.