Filter
Top Products
Figure 5.
-10- G1023 Heavy-Duty Table Saw
8. If the wing tilts down, remove the wing and
stick layers of masking tape under each bolt
near the bottom edge. Re-install the wing
and check the flushness again.
9. If the wing tilts up, remove the wing and stick
layers of masking tape over each bolt near
the top edge. Re-install the wing and check
the flushness again. Figure 5.
Masking Tape
Figure 4.
Guard Support Shaft
Install the guard support shaft before installing
the blade. This will eliminate the risk of acciden-
tally touching the sharp edges of the blade while
working inside the saw cabinet.
1. Push the threaded end of the shaft through
the hole in the back of the saw until the
shoulder on the shaft stops it.
2. Secure the shaft with the hex nut provided.
Figure 6.
Figure 6.