Filter
Top Products
G1023 Heavy-Duty Table Saw -25-
SECTION 6: MAINTENANCE
V-Belt
To ensure optimum power transmission from the
motor to the blade, the V-belts must be in good
condition and operate under proper tension.
When replacing V-belts, it is important to replace
all three at the same time-even if they do not all
appear worn. Even power transmission will be
ensured.
Belt tension should be checked at least every 3
months: more often if using the table saw inten-
sively.
The V-belts are accessed through the cavity on
the right side of the saw. They link the arbor and
motor pulleys. To check V-belt tension:
1. Squeeze the center of each V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4". Figure 37.
Figure 37.
Keeping your table and wings slippery makes it
easier to slide your wood when making cuts. We
recommend the following types of products:
1. Carnauba wax. First clean the table top
thoroughly and apply a thin layer.
2. Talcum powder. Clean the table and sprin-
kle the table with it. Rub it in with a hard felt
pad such as a school blackboard eraser. The
talc will fill the pores of the iron and act as a
rust inhibitor.
3. Coat the table surface with any number of
cast iron table dressing sprays. These act as
a rust and friction inhibitor and are designed
especially for woodworking equipment.
Do not use paraffin or similar waxes because
they leave residues and create more friction
instead of less friction. Do not use silicon based
lubricants. They can rub off onto the wood and
prevent it from taking stains and finishes proper-
ly.
Table and Wings