Filter
Top Products
G1023 Heavy-Duty Table Saw -11-
Figure 7.
Blade
The Model G1023 is not supplied with a blade.
For a selection of blades, including dado sets,
refer to the Grizzly catalog for selection, price and
ordering information. To install the blade:
1. Remove the arbor nut and outside arbor
flange from inside the blade cavity. Figure 7.
The arbor nut and arbor are left hand thread-
ed.
2. Slide the saw blade over the arbor. Ensure
that the blade teeth point toward you when
standing at the front of the saw.
3. Use the arbor wrench provided with the saw
to tighten the arbor nut and secure the blade.
Wedge a block of wood in the teeth to keep
the blade from turning when tightening the
nut. Be sure the arbor flanges are on either
side of the blade.
4. When removing the blade, use the same
block of wood to wedge the blade and the
nut will come off easily.
2. Set a combination square against the face of
the guard. Slightly rotate the rear bracket to
adjust the face of the blade guard perpendic-
ular to the table top. Figure 9.
Figure 8.
Figure 9.
Blade Guard
1. Slip the blade guard/splitter over the mount-
ing bolts. Figure 8. The washers should be
between the bolt head and the slots. Tighten
the bolts to secure the blade guard/splitter.