Filter
Top Products
-14-
G1052 9" Bandsaw
Table Adjustments
The bandsaw table will tilt left 15° and right 45°.
To tilt the table:
1. Loosen the locking handle below the table.
Figure 12.
Locking Handle
Angle Gauge
Figure 12. Table adjustment locations.
Figure 13. Squaring the blade to the table.
If the blade is not centered in the table insert, the
table can be shifted side to side for adjustment.
1. Loosen the table locking handle.
2. Shift the table to center the blade in the table
insert.
3. Secure the table by re-tightening the locking
handle. Check table position to ensure that
undesirable shifting did not occur during re-
tightening.
If the table will not shift adequately, you will need
to reposition the blade.
2. Tilt the table to the desired angle. Refer to
the angle gauge on the table bracket.
Double-check proper angle adjustment by
placing a machinist’s or combination square
against the table and blade and adjust until
perpendicular. Figure 13.
3. Re-tighten the locking handle.