Filter
Top Products
G1052 9" Bandsaw -19-
Cutting Curves
When cutting curves, simultaneously feed and
turn the stock carefully so that the blade follows
the layout line without being twisted. If a curve is
so abrupt that it is necessary to repeatedly back
up and cut a new kerf, use either a narrower
blade or a blade with more set. A blade with more
set can cut relatively tighter radii, though the cut
is usually rougher than cuts produced by a blade
with medium set.
Always make short cuts first, then proceed to the
longer cuts. Relief cuts will also reduce the
chance that the blade will be pinched or twisted.
Relief cuts are cuts made through the waste por-
tion of the workpiece and are stopped at the lay-
out line. As you cut along the layout line, waste
wood is released from the workpiece, alleviating
any pressure on the back of the blade. Relief cuts
also make backing the workpiece out easier, if
needed.
Stacked Cuts
One of the benefits of a bandsaw is its ability to
cut multiple copies of a particular shape by stack-
ing a number of workpieces together.
Before making stacked cuts, it is essential to
ensure that both the table and the blade are prop-
erly adjusted to 90°. Otherwise, any error will be
compounded with each piece cut from the top to
the bottom of the stack.
To complete a stacked cut:
1. Align your pieces from top to bottom to
ensure that each piece has adequate scrap
to provide a clean, unhampered cut.
2. Using brads in the waste portion of each
piece, secure all the pieces together.
3. Lay out the shape you intend to cut on the
face of the top piece.
4. Make relief cuts perpendicular to the outline
of your intended shape in areas where
changes in blade direction could strain the
woodgrain or cause the blade kerf to bind.
5. Cut the stack of pieces as though you were
cutting a single piece. Follow you layout line
with the blade kerf on the waste side of your
line.
BLADE WIDTH
1
/8"
1
/4"
3
/8"
1
/2"
MINIMUM RADII
3
/16"
5
/8"
1
1
/2"
2
1
/2"
Crosscutting
In addition to its ability to rip lumber, the bandsaw
is capable of crosscutting lumber as thick as 4
1
/8".
Use the miter gauge when making straight cross-
cuts to push your workpiece through the blade.
When making angled crosscuts, adjust the miter
gauge to the angle you desire and use it to guide
your workpiece along the blade.
If your workpiece is cylindrical, you will need a V-
groove jig to support the material you wish to cut.