Filter
Top Products
-20-
G1052 9" Bandsaw
SECTION 7: MAINTENANCE
Shielded and pre-lubricated ball bearings require
no lubrication for the life of the bearings. All bear-
ings are standard sizes and replacements can be
purchased from our parts department or your
local bearing supply store.
As for other items on this machine, such as
adjustment controls, an occasional “shot” of light
oil is just about all that is necessary. Before
applying, however, wipe off any sawdust with a
clean cloth or towel and spray on the lubricant.
Make a habit of inspecting your bandsaw each
time you use it. Check for the following conditions
and repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Any other condition that could hamper the
safe operation of this machine.
The table and other non-painted surfaces on the
Model G1052 should be protected against rust
and pitting. Wiping the saw clean after every use
ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Most experienced woodworkers recommend
using automotive paste wax on exposed steel
and cast iron surfaces. The wax provides a layer
of protection, as well as reducing friction between
lumber and the table, making cuts faster and
smoother.
Avoid waxes that contain silicone or other syn-
thetic ingredients. These materials can find their
way into lumber that’s being worked, and can
make staining and finishing difficult. If you use
paste wax, make sure that it’s 100% Carnauba
wax.
DO NOT make adjustments or attempt main-
tenance procedures while the Model G1052
is running. Ensure that the switch is off,
power is disconnected and moving parts
have stopped before making adjustments.
Failure to comply may result in serious per-
sonal injury.
General
Lubrication
Table