Filter
Top Products
G1052 9" Bandsaw
-5-
110V Operation
SECTION 2: CIRCUIT REQUIREMENTS
The Model G1052 has a
1
/2 HP motor which oper-
ates at 110V. It includes a complete cordset with
a grounded plug that’s made for use with a
grounded domestic 110V outlet.
The G1052 motor will safely draw about 8 amps
at 110V under load. If you operate the bandsaw
on any circuit that is already close to its capacity,
it might blow a fuse or trip a circuit breaker.
However, if an unusual load does not exist, and
power failure still occurs, have the circuit inspect-
ed by a qualified electrician.
The Model G1052 should be fused at 15 amps.
Fusing at amperage ratings higher than 15 amps
will not adequately protect the motor. You are
cautioned that equipment that is returned to us
for service that shows evidence of being over-
fused will be repaired or replaced totally at the
customer’s expense, regardless of the present
warranty status.
Fusing
Figure 1. Recommended outlet/plug configuration.
If you find it necessary to use an extension cord
with the Model G1052, make sure the cord is
rated Hard Service (grade S) or better. Refer to
the chart in the standard safety instructions to
determine the minimum gauge for the extension
cord. The extension cord must also contain a
ground wire and plug pin. Always repair or
replace extension cords when they become worn
or damaged.
Extension Cords
Grounding
This equipment must be grounded, there is
a risk of severe electrical shock. Verify that
any existing electrical outlet and circuit you
intend to plug into is actually grounded. If it is
not, it will be necessary to run a separate 14
A.W.G. copper grounding wire from the outlet
to a known ground. Consult a qualified electri-
cian if you are uncertain of the grounding of
your electrical system. Under no circum-
stances should the grounding pin from any
three-pronged plug be removed. Serious
injury may occur.
In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. This tool is equipped with a power cord
which has an equipment grounding conductor.
The outlet must be properly installed and ground-
ed in accordance with local codes. Refer to
Figure 1 for the proper outlet and plug configura-
tion.