Filter
Top Products
-10- G1073/G1073Z 16" Bandsaw
SECTION 4: ASSEMBLY
Figure 3. Attaching motor mount bracket.
Figure 4. Motor attached to motor mount bracket.
Stand (G1073)
The stand assembly on the Model G1073 is
shown here. If you have the Model G1073Z, fol-
low the same instructions for mounting the motor,
bandsaw to stand, and the anti-vibration pads.
Disregard the steps that do not apply.
To ease assembly, build the stand upside down
on a bench, then place it upright on the floor. Do
not fully tighten any of the bolts until directed to
do so in the next section.
Sometimes sheet metal parts have a tendency to
''spring'' after they are formed. For this reason,
you may need to use a little extra force to align
holes to insert bolts.
2. Position the motor so the pulley is over the
rectangular hole in the stand top as shown in
Figure 4. Secure with four (4)
5
⁄16"-18 x 1"
carriage bolts,
5
⁄16" washers, and
5
⁄16"-18 nuts
provided.
To assemble the stand:
1. Flip the top of the stand upside-down.
Position the motor mounting bracket so that
it sits over the four (4) evenly spaced holes
in the top. Bolt the bracket to the stand with
two (2)
3
⁄8"-16 x 1" hex bolts,
3
⁄8" washers,
and
3
⁄8"-16 nuts provided. Hand tighten for
now so your assembly looks like Figure 3.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.