Filter
Top Products
-16- G1073/G1073Z 16" Bandsaw
Figure 15. Belt guard and dust port mounted
correctly on bandsaw.
Guard
Place the belt guard over the step pulley and
secure it, as shown in Figure 15, to the stand
using the
1
⁄4"-20 x
1
⁄2" hex head bolts, washers,
and nuts provided. Fasten the guard to the band-
saw by inserting the threaded rod through to the
body casting and tightening the knob.
Dust Port
The Model G1073 comes standard with a 2
1
⁄2"
dust port for dust collection. It mounts to the lower
rear casting body. This port can be connected
directly to a 2
1
⁄2" Shop•Vac
®
hose or adapted to fit
a standard 4" dust collector hose by using the
Grizzly Model G3119 adapter between a 2
1
⁄2" and
4" hose.
To mount the dust port:
1. Remove the four dust port mounting screws
from the bandsaw body and position the dust
port as shown in Figure 15.
2. Replace the screws and secure the dust port
to the bandsaw body.
Dust Port
Belt Guard