Filter
Top Products
G1073/G1073Z 16'' Bandsaw -29-
SECTION 7: MAINTENANCE
V-Belts
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition and operate under proper tension. The
belts should be checked for cracks, fraying and
wear. Belt tension should be checked at least
every 3 months; more often if the bandsaw is
used daily.
The V-belt is accessed via the bottom cover:
1. Squeeze the center of the V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4". See “V-Belt
Adjustment” instructions.
The table and other non-painted surfaces on the
Model G1073/G1073Z should be protected
against rust and pitting. Wiping the saw clean
after every use ensures that wood dust is not
allowed to trap moisture against bare metal sur-
faces.
The table can be kept rust-free with regular appli-
cations of products like SLIPIT
®
or Boeshield
®
T-
9. For long term storage you may want to consid-
er products like Kleen Bore's Rust Guardit™. See
the current Grizzly catalog for more on these
products.
Table
Shielded and pre-lubricated ball bearings require
no lubrication for the life of the bearings. All bear-
ings are standard sizes, and replacements can
be purchased from our parts department or bear-
ing supply store.
As for other items on this machine, such as
adjustment controls, an occasional “shot” of light
oil is just about all that is necessary. Before
applying, however, wipe off any sawdust with a
clean cloth, towel or dry paint brush, and spray on
the lubricant. Ensure that oil does not get on the
pulleys or V-belt because it could cause belt dete-
rioration and slipping.
Lubrication
Always be aware of the condition of your band-
saw. Routinely check the condition of the follow-
ing items and repair or replace as necessary:
• Loose mounting bolts
• Worn switch
• Worn or damaged blade
• Worn or damaged support bearings or guide
bearings
Miscellaneous
Always disconnect
power to the machine
when making adjust-
ments. Failure to do this
may result in serious
personal injury.