Filter
Top Products
-18-
G4015Z Lathe/Mill
Drill Chuck
The Model G4015Z comes supplied with a drill
chuck and arbor that can be used in the tailstock
on the lathe or in the spindle for the drill press.
The arbor and drill chuck are assembled and
installed into the spindle for the drill press spindle
at the factory.
Drill Chuck Removal
To remove the drill chuck from the drill press:
1. Unplug the machine.
2. Return the spindle to the highest position.
3. Remove the small plastic cap on top of the
belt guard.
4. Grasp the drill chuck with one hand and
unscrew the draw bar 3 turns with the other.
5. Secure the quill with the quill lock.
6. Tap on the end of the draw bar with a soft
faced mallet as in Figure 11. Do Not use a
steel hammer! Damage to the draw bar,
such as chipping, may occur.
7. Once the arbor has become loose, hold the
drill chuck with one hand while unthreading
the remainder of the draw bolt.
Figure 11. Removing drill chuck.