Filter
Top Products
-28-
G4015Z Lathe/Mill
Apron Gib - There are 2 setscrews that tension
the saddle gib. Before making adjustments to the
saddle gib, ensure that the front lock lever is
loose by turning it counterclockwise. See Figure
30.
It is important the setscrews are tightened even-
ly. A slight drag should be detected while turning
the hand crank at the end of the lathe.
Figure 30. This bolt locks the apron in place.
Head Stock
The Head Stock can be adjusted up or down to
suit height requirements for different workpieces.
Figure 31 shows the locking setscrew and lifting
mechanism. To adjust the height, loosen the
locking setscrew and rotate the lifting levers.
When the Head Stock is at the desired height,
lock in place with the lever. The Head Stock can
be rotated around the column allowing it to be
positioned out of the way during lathe operations.
Figure 31. Elevating the Head Stock.