Filter
Top Products
-32-
G4015Z Lathe/Mill
If the direction is reversed, contact our service
department for further instructions.
4. If the lathe/mill is running correctly, push the
stop button, wait for the machine to come to
a complete stop and take some time to
review the various controls.
Keep clothing rolled up
and out of the way of
machinery and keep
hair pulled back.
Wear safety glasses dur-
ing all operations on the
shaper. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Test Run
Now that the lathe is securely in place and you’ve
read the safety guidelines, it’s time to give the
machine a test run.
Before starting the machine:
1. Make sure the machine is properly ground-
ed, the power switch is in the “OFF” position
and the reversing switch is selected for for-
ward.
2. Inspect the machine to ensure that all hand
tools are out of the way, guards are in place
and nothing is impeding the movement of
the chuck. Check this by rotating the chuck
by hand.
3. Rotate the System Reset Button and allow it
to pop out. Push the start button on the con-
trol panel while keeping a finger poised over
the stop button. The machine should run
smoothly with little or no vibration or rubbing
noises when it starts. Strange or unnatural
noises should be investigated and corrected
before operating the machine further.
Inspect your machine for
loose nuts and bolts, and
ensure no tools are left in
or around the machine
before reconnecting
power.