Filter
Top Products
Page 2SKU 43378
Specications
Motor
120 VAC, 60 Hz, 3/4 HP, 1750 RPM; 5.8 amps
(with load)
16 Spindle Speeds
220, 300, 430, 480, 590, 650, 720, 850, 950,
1600, 1900, 2000, 2500, 2900, and 3600 RPM
Spindle Stroke: 3-1/8 inches; Taper: MT2
Column 2-7/8 (diameter) inches
Base Dimensions 10-1/8 x 17-1/2 inches; Slots: 5/8”
Throat Depth 6-5/8 inches (of 13 inch swing)
Chuck Capacity 7/64 to 5/8 inches; Taper: JT3
Table Slot 5/8 inches
Table Rotation 360°; Tilt: 45° (left and right)
Table Size 11-5/8 (diameter) inches
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of ammable gases or liquids.
3. Keep children away. Children must never be allowed in the work area. Do not let
them handle machines, tools, or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
5. Do not force tool. It will do the job better and more safely at the rate for which it
was intended. Do not use inappropriate attachments in an attempt to exceed the tool
capacity.
6. Use the right tool for the job. Do not attempt to force a small tool or attachment to
REV 00j
E105017
36ZJ