Filter
Top Products
Page 8SKU 43378
8. Using two people, lift the Head Assembly up and onto the Column (B1).
It should slide down on the Column Tube as far as it will go. Align it so that it faces
straight forward, inline with the Base.
9. Screw in two Set Screws (21), into each side of the Head (1) and tighten with the Allen
wrench.
10.
Head Lock Set Screws (21)
Head Assembly
Motor (13)
Hex Screw (17)
Washer (15)
Hex Nut (14)
Belt Tension
Lever (19)
Belt Tension
Lock Knob (18)
Mount the Motor (13) onto the Head Assembly (see photo above).
- Place a Washer (15) on each of four Hex Screws (17)
- Insert Hex Screws into the Motor Mount (8) (from left to right as shown above).
- Position the Motor base slots over the Hex Screws.
- Place a Washer (15) and Hex Nut (14) on each Hex Screw (17). Hand tighten.
- Position the Motor shaft at the center of the Pulley Cover (A23).
11. Install the Motor Pulley (11).
- Slide the Motor Pulley onto the Motor shaft.
- Line up the at notch on the shaft with at notch on the pulley.
- The pulley should not touch the lower Pulley Cover (A23).
- Tighten the Motor Pulley onto the shaft using the Allen wrench and Set Screw (12).
12.
Motor Pulley (11)
Set Screw (12)
Pulley Assembly
Speed-Belt Chart
Spindle Pulley (A3)
Idler Pulley (A19)
V-belt (A1)
V-belt (A1)
Pulley Cover (A23)
Adjust the height of the Motor Pulley.
- Lay a straight edge across the two pulleys.
Rev 07i