Filter
Top Products
SKU 45804 PAGE 11
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer
to the Assembly Diagrams on pages 20 and 21 of this manual.
To Attach The Bottom Plate:
1. Turn the saw Base (188) over, and position the
Bottom Plate (193) in place. (See Figure D.)
2. Line up the four holes. Secure Bottom Plate in
place using the 4 cross head screws (be careful
not to overtighten) that are packed in the small
plastic bag included in the box.
To Install A Saw Blade:
1. WARNING! Prior to installing a Saw Blade (3), make sure the Table Saw
is disconnected from its electrical power source.
To help prevent injury, heavy work gloves are recommended
when replacing the blade.
2. Unscrew the two Screws (96) located on the Cover (101), and remove the Cover to
expose the Saw Blade opening. (See Figure E.)
HEX BOLT (1)
FLAT WASHER (2)
WASHER “A” (3)
SCREW (96)
COVER (101)
SCREW (96)
FENCE ASSY. (75)
FIGURE E
SAW BLADE (3)
(not included)
SHAFT (#7)
(REMOVED)
FIGURE D