SKU 45804 PAGE 14
OPERATING INSTRUCTIONS
To Raise And Lower The Saw Blade:
1. When cutting, the top edge of the Saw Blade (3) should rise about 1/4” above the
top edge of the workpiece.
2. To raise the height of the Saw Blade (3), unlock the Locking Knob (167) by turning it
counterclockwise. Next, turn the Wheel (170) clockwise until the desired height is
acquired. Then, turn the Locking Knob clockwise to lock the Saw Blade in position.
(See Figure M.)
3. To lower the height of the Saw Blade (3), unlock the Locking Knob (167) by turning
it counterclockwise. Next, turn the Wheel (170) counterclockwise until the desired
height is acquired. Then, turn the Locking Knob clockwise to lock the Saw Blade
in position. (See Figure M.)
To Adjust The Angle Of The Saw Blade:
1. The Table Saw is capable of making cuts from 90 degrees to 45 degrees.
2. The Table Saw also features an Angle Scale and Angle Indicator on the front side
of the unit. (See Figure M.)
BLADE GUARD
ASSY. (50)
SAW BLADE (3)
(not included)
RULER SUPPORT
(86)
LOCKING KNOB (167)
GRADUATION
SCALE
ANGLE INDICATOR
ANGLE
SCALE
SWITCH
(179)
WHEEL
(170)
FENCE HANDLE (80)
(LOCKED POSITION)
FENCE ASSY. (75)
FIGURE M
CIRCUIT
BREAKER
(178)