Filter
Top Products
Page 4SKU 47158
For technical questions, please call 1-800-444-3353.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work area
free of obstructions, grease, oil, trash, and other debris. Do not use the Micro
Mill/Drill Machine in areas near flammable chemicals, dusts, and vapors. Do not
use the Micro Mill/Drill Machine in a damp or wet location.
2. GROUND THIS PRODUCT. The electrical Power Cord/Plug (part #128) for this
product is equipped with a grounded, 3-prong Plug. Never remove the grounding
prong or modify the Plug in any way. Do not use adapter plugs with this product.
To comply with the National Electric Code, and to provide additional protection
from the risk of electrical shock, this product should only be connected to a 120
Volt, 3-hole electrical outlet that is protected by a Ground Fault Circuit Interrupter
(GFCI). (See Assy. Diagram.)
3. IF AN EXTENSION CORD (not provided) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND
LENGTH. (See Figure A.)
FIGURE A
AWG RATING CHART - 120 VOLT
4. KEEP ALL SAFETY GUARDS IN PLACE, IN PROPER ADJUSTMENT, AND IN
PROPER ALIGNMENT.
5. REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Forward/Re-
verse Switch (part #125) is in the “OFF” position before plugging the Power Cord/
Plug (part #128) into a grounded, 3-hole, 120 Volt, electrical outlet.
(See Figure B, and Assy. Diagram.)
6. PRIOR TO STARTING THE MICRO MILL/DRILL MACHINE, MAKE SURE ALL
ADJUSTING KEYS AND WRENCHES ARE REMOVED FROM THE TOOL.
7. DO NOT USE ROTARY PLANERS, WIRE WHEELS, OR ROUTER BITS ON
THIS MICRO MILL/DRILL MACHINE.