SKU 06852 For technical questions, please call 1-800-444-3353. PAGE 13
To Adjust The Sand Belt Frame For Vertical Sanding:
Loosen the two Nuts (36) on the Sanding Belt Frame (40), and with assistance
raise the Sanding Belt Frame to its full vertical position. Then, firmly retighten the
two Nuts to lock the Sanding Belt Frame in place. (See Figure L.)
To Adjust The Position Of The Table:
1. When the Sanding Belt Frame (40) is in its vertical position, the Table (1) should be
repositioned to the front of the Sanding Belt Frame. (See Figure M, next page.)
2. To reposition the Table (1), loosen the two Set Screws (14) and remove the Table,
including the Support Bar (18). (See Figure M.)
3. Insert the Support Bar into the Mounting Hole, and tighten the other two Set Screws
(14). (See Figure M.)
MITER GAUGE
(3)
MITER GAUGE KNOB
ANGLE SCALE
FIGURE K
NUT (36)
SANDING BELT FRAME (40)
(VERTICAL POSITION)
FIGURE L
REV 04b