Filter
Top Products
SKU 06852 For technical questions, please call 1-800-444-3353. PAGE 5
9. ALLOW THE SANDING BELT/DISC (2, 15) TO TURN UP TO FULL SPEED
BEFORE FEEDING A WORKPIECE INTO THE SANDING BELT/DISC. When
turning off the Belt/Disc Sander, allow the Sanding Belt/Disc to slow down and
stop on its own. Do not press against the Sanding Belt/Disc to stop it.
10. FEED THE WORKPIECE INTO THE SANDING BELT/DISC (2, 15) GRADU-
ALLY. Do not force the machine to remove material faster than it was designed
to cut.
11. TO AVOID PERSONAL INJURY AND/OR DAMAGE TO THE MACHINE,
ALWAYS ALLOW APPROXIMATELY 1/16” CLEARANCE BETWEEN THE
SANDING BELT (2) AND THE BACK STOP (39).
12. ALWAYS ALLOW APPROXIMATELY 1/16” CLEARANCE BETWEEN THE
SANDING DISC (15) AND THE TABLE (1).
13. WHEN SANDING A LARGE WORKPIECE, MAKE SURE ITS ENTIRE LENGTH
IS PROPERLY SUPPORTED. If necessary, use a roller stand (not included) with
a larger workpiece.
14. NEVER ATTEMPT TO REMOVE MATERIAL STUCK IN THE MOVING PARTS
OF THE BELT/DISC SANDER WHILE IT IS PLUGGED IN AND RUNNING.
15. NEVER STAND ON THE BELT/DISC SANDER. Serious injury could result if the
Belt/Disc Sander is tipped or if the turning Sanding Belt/Disc (2, 15) are acciden-
tally contacted.
16. ALWAYS TURN THE POWER SWITCH (53) TO ITS “OFF” POSITION AND UN-
PLUG THE BELT/DISC SANDER FROM ITS ELECTRICAL SUPPLY SOURCE
BEFORE PERFORMING ANY INSPECTION, ADJUSTMENTS, MAINTE-
NANCE, OR CLEANING PROCEDURES.
17. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are: lead from lead-based paints, and arsenic and chromium
from chemically treated lumber. Your risk from these exposures varies depending
on how often you do this type of work. To reduce your exposure to these chemi-
cals: work in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out microscopic
particles.
(California Health & Safety Code § 25249.5, et seq.)