Filter
Top Products
SKU 91130 For technical questions, please call 1-800-444-3353. Page 25
5. Feed the workpiece gradually from right to left against the rotation of the cutter.
Keep the feed rate constant. Feeding the workpiece too quickly will slow the
Motor of the machine. Feeding the workpiece too slowly will cause burns to the
workpiece.
6. On very hard wood or large cuts it may be necessary to make more than one
pass at progressive depth settings until the desired depth of cut is made.
7. When finished, depress the Safety Cover (10B) to turn off the Router Table.
Then, unplug the Power Cord/Plug from its electrical outlet.
INSPECTION, MAINTENANCE, AND CLEANING
1. CAUTION! Always turn the Power Switch (9B) to its “STOP” position
and unplug the Power Cord (1B) from its 120 volt electrical outlet before
performing any inspection, adjustments, maintenance, or cleaning.
2. BEFORE EACH USE, inspect the general condition of the Router Table. Check
for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, loose router bit, and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs, have the
problem corrected before further use.
Do not use damaged equipment.
3. DAILY: With a soft brush, cloth, or vacuum, remove all sawdust and debris from
the Router Table, particularly, the machine’s Dust Port (26C) and Main Table
(20B), Then, use a premium quality, lightweight machine oil to lubricate all mov-
ing parts. Do not use solvents or caustic agents to clean the Router Table.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL
RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.