Filter
Top Products
Page 10For technical questions, please call 1-800-444-3353.SKU 97896
SPECIFICATIONS
Electrical Requirements 120 V~ / 60 Hz / 15 A
Motor (No Load Speed) 2.4 HP (5,000 RPM)
Blade Size 10” Dia. / 5/8” Arbor
Table Dimensions 16” L x 26” W
Adjustable Rip Fence
Size
17” L x 1” W x 2” H
Max Blade Tilt
0-45° (Left Tilt Only)
2° Increments
Dust Chute 3”
Cutting Capacity
2-3/4” @ 90°
2-1/2” @ 45°
Weight 32.6 lb.
230181
Accessories Include:
1 Blade Wrench
1 Mitre Gauge
1 Push Stick
1 Rip Fence
Recommended Blade (not included):
SKU 529 - 10” / 40 Tooth Saw Blade
Recommended Mounting Stand (not included):
SKU 98000 - Folding Leg Stand
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged and
that parts shown on the Parts Lists and
Assembly Diagrams are included. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
Note: While unpacking and before attempting
assembly; loosen the motor, remove the
two Styrofoam inserts that hold the motor
in place during packing, and retighten
motor.
INSTRUCTIONS FOR PUTTING
INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the tool
to its “OFF” position and unplug
the tool from its electrical outlet
before assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Mounting Instructions
If mounting onto Foldable Leg Stand
(SKU 98000):
Foldable Leg Stand (SKU 98000) has 1.
been designed to support this Table
Saw. Mount the Saw according to the
instructions, warnings, and precautions
available in the Foldable Leg Stand
(SKU 98000) manual.
If you are mounting Table Saw to a leg 2.
stand other than SKU 98000, make
sure the stand is designed to handle
the weight of this machine, plus any
additional weight placed on it during use.
Also, make sure that the stand will match
the base of this stand properly.