Filter
Top Products
Page 16For technical questions, please call 1-800-444-3353.SKU 97896
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual must
be performed only by a qualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Always disconnect
the Table Saw from its electrical
outlet before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, improper
mounting of the Saw Blade (3) and any
other condition that may affect its safe
operation.
Remove cut-off pieces and scraps 2.
from the Table before starting the
Table Saw. Switch off the tool. While
the Saw Blade (3) is completely stopped;
unplug the machine, remove the Blade
following the instructions on pages 11
and 12, and remove all debris. With a
brush, soft cloth, or vacuum, remove all
sawdust from the Table Saw.
Allowing sawdust, scraps, or other
debris to accumulate can cause a re,
resulting in severe personal injury or
property damage.
Do not use solvents to wipe off the 3.
Table Saw, as damage may result. If
necessary, wipe with a damp cloth. You
may use a mild detergent.
Do not introduce water into the
electric motor through the motor
vents.
Once clean, lubricate all moving parts 4.
with a light oil.
When storing, keep the Table Saw 5.
covered with a cloth cover.
WARNING! 6. If the supply cord of this
power tool is damaged, it must be
replaced only by a qualied service
technician.
PLEASE READ THE FOLLOWING
CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY.
NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED
TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND
NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.