Filter
Top Products
Page 12For technical questions, please call 1-800-444-3353.SKU 97896
To Attach Blade Guard Assembly
WARNING! Prior to installing the 1.
Blade Guard, make sure the Table
Saw is disconnected from its
electrical power source.
FIGURE B
Mounting
Post
2. Put the Blade Guard Assembly in place
over the table. The Support Base (164)
of the Guard Assembly attaches to the
mounting post shown in Figure B,
above.
FIGURE C
3. Slip the Support Base (164) over the
mounting post. Place a Spring Washer
(156) and Flat Washer (163) over the
Hex Bolt (162) and thread into the end
of the mounting post. Use the included
Hex Wrench (165) to tighten the Hex Bolt
(162). See Figure C above.
Use the Hex Wrench (165) to tighten all 4.
the Hex Bolts in place along the Support
Base (164) of the Guard Assembly.
FIGURE D
BLADE
BOARD
(152)
5. To adjust the height of the Blade Guard,
loosen the Hex Bolt (160) along the
side of the Blade Board (152). Once the
screws are loosened, adjust the Blade
Board to the desired height. See Figure
D, above.
After making any adjustments to Blade 6.
Guard, make sure the guard is aligned
properly and does not contact the Blade
(3).
To Attach Fence Assembly
WARNING! Prior to installing the 1.
Fence, make sure the Table Saw is
disconnected from its electrical power
source.
To attach Fence (123) to Work Table 2.
(86), raise the Fence Handle (132) to a
horizontal position. Slip the Front Board
(134) of the fence over the front edge of
the Table (86).