Filter
Top Products
Page 15For technical questions, please call 1-800-444-3353.SKU 97896
After the cut is under way, use the Push 6.
Stick (168) to continue guiding the
workpiece forward. Just before the cut
is near completion, move the left hand
safely away from the workpiece and the
Saw Blade (3). Then, continue pushing
workpiece into Saw Blade with Push
Stick, until the cut is complete. See
Figure H.
Once the cut is complete, continue 7.
to maintain control of the workpiece.
Turn the Switch (103) to its OFF
position. Then, wait until the Saw Blade
(3) completely stops rotating before
removing the workpiece.
Table Saw Overload Protection
The Table Saw is equipped with a Circuit 1.
Breaker (104). If the motor shuts off or
fails to start due to overloading (cutting
stock too fast, using a dull Saw Blade
(3), low voltage, using the Table Saw
beyond its capacity, etc.), turn the Switch
(103) to its OFF position. The Switch
is also equipped with a safety pull that
immediately triggers the circuit breaker.
Let the motor cool three to ve minutes 2.
and reconnect the safety pull before
pushing the Circuit Breaker button. This
will reset the overload device. The motor
can then be turned on again in the usual
manner.
When stacking dado blades, you should 3.
be familiar with safe work practices
and follow the directions of the blade
manufacturer during dado cuts. Stacked
dado blade thickness should not exceed
0.33”. Always make sure that all mating
faces are clean and fee of sawdust and
debris.
REV 10h