Filter
Top Products
Page 6For technical questions, please call 1-800-444-3353.SKU 97896
Fence must be completely parallel to •
the saw blade.
Workpiece must be free from aws •
(such as loose knots) and from foreign
objects (such as nails and screws).
Support large workpieces along their •
entire length. Large workpieces tend to
bend, grabbing the blade.
Do not use a dull, damaged, or pitch-•
covered blade.
Do not use fence as a guide when •
crosscutting.
Do not ripcut a twisted or warped •
workpiece, or workpiece without
straight edge to guide along fence.
Maintain control of the workpiece. Do •
not allow the workpiece to rest against
the moving blade without holding onto
it.
If the blade binds or a cut is •
interrupted, turn off the power switch
and hold the workpiece still until the
blade stops. Correct the cause of
blade binding before proceeding.
Before continuing an unnished cut, •
center the blade in the pre-cut kerf
and check that the saw teeth are not
engaged into the workpiece before
turning on the saw.
Push the wood stock past the blade •
prior to release.
Check guards for proper operation with 11.
saw disconnected from power before
each use. Do not disable any guard. Do
not operate saw if any movable guard
does not move freely and close instantly.
Make sure any movable guard does not
touch the blade in all angles, depths of
cut, and positions.
Keep the guard in place while through-12.
sawing. Verify that the spreader lines up
with the blade to prevent binding.
Construct an appropriate Push Stick out 13.
of wood according to the guidelines on
the following page.