Filter
Top Products
-23-
WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the
crown molding might be thrust from the table and cause bodily harm.
Do not perform bevel cutting. The main body or the saw blade may contact the sub
fence, resulting in an injury.
CAUTION: Always confirm that the motor head does not contact the crown molding vise ass’y when
it is lowered for cutting. If there is any danger that it may do so, loosen the 6 mm knob
bolt and move the crown molding vise ass’y to a position where it will not contact the
saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding stoppers as shown in Fig. 32-b. Adjust the crown molding
stoppers according to the size of the crown molding. Tighten the 6 mm wing bolt to secure the crown
molding stoppers. Refer to the following table for the miter angle.
Position in Fig. 26
Miter angle Finished piece
1
Right 45° Save the right side of blade
For inside corner
2
Save the left side of blade
3
Left 45°
Save the right side of blade
For outside corner
4
Right 45° Save the left side of blade
Table 9