Filter
Top Products
-32-
6. Laser marker
(1) Remove the Machine Screw M4 x 8 [81] and
remove the Cover [83] from the rear of Hinge (A)
Ass’y [87].
(2) Remove the three Machine Screws M4 x 8 [108]
and remove Plate (A) [105] and Cover (A) [104]
from Hinge (A) Ass’y [87].
(3) Remove the Adjuster [88] and push the Clutch
Screw [96] from behind Hinge (A) Ass’y [87].
Then Holder (B) [106] can be removed together
with the Laser Marker [107].
NOTE: At this time, the Spring [100] and the
Clutch Spring [101] pop out. Be careful
not to lose them.
(4) Remove the Clutch Screw [96]. Then the Laser
Marker [107] can be removed from Holder (B)
[106].
NOTE: At this time, the two Springs [102] pop out.
Be careful not to lose them.
7. Vise ass’y
(1) Remove the Wing Bolt M6 x 15 [36] to remove the
Vise Shaft [39].
(2) Remove the Machine Screw M4 x 10 [41] to
remove the Vise Plate [40].
(3) Remove the Knob Bolt M10 x 66 [35] from the
Screw Holder [37].
Fig. 45
Fig. 44