Hitachi C 8FSE Battery Charger User Manual


 
-5-
Compound miter and bevel cutting
HITACHI
C 8FSE
C 8FSHE
C 8FB2
P1 and P2 P3 B
Miter left/right
45°
Bevel left 45°
Height x Width
(H x W)
45 x 220
(1-25/32” x 8-21/32”)
50 x 170
(1-15/16” x 6-11/16”)
with aux. board
width 30(1-3/16”)
45 x 220
(1-25/32” x 8-21/32”)
48 x 190
(1-7/8” x 7-15/32”)
50 x 212
(1-15/16” x 6-11/32”)
42 x 190
(1-21/32” x 7-15/32”)
Miter left/right
45°
Bevel right
45°
Height x Width
(H x W)
60 x 220
(2-9/16” x 8-21/32”)
70 x 170
(2-3/4” x 6-11/16”)
with aux. board
width 30(1-3/16”)
----
By turning the turn table to the left or right and inclining the saw blade section (head) to the left or right, the
Models C 8FSE and C 8FSHE are capable of compound cutting (bevel and miter, see Figs. 10-a and 10-b)
of workpieces with the maximum dimensions shown in Table 6.
Splinter guard, also serving for cut alignment
When cutting the ends of a workpiece, splinters may drop on the saw blade and be cut into pieces. The
Models C 8FSE and C 8FSHE are equipped with a splinter guard to prevent such splinter cutting.
(Refer to "SELLING POINTS .") Safe cutting is also ensured in bevel cutting because the splinter guard
is tilted with the saw blade.
Groove cutting
The Models C 8FSE and C 8FSHE can cut grooves at desired depth by adjusting the 6-mm depth adjustment bolt
manually. (Refer to "Groove cutting procedures" described in the Instruction Manual for details.)
NOTE: The Models C 8FSE and C 8FSHE cannot cut grooves at constant depth unless the saw blade
slides in parallel with the base surface.
Table 6
Fig. 10-bFig. 10-a
Unit: mm (inch)
Max.
cutting
d
im
e
n
s
i
o
n
Maker
Model
Base surface
Workpiece
Saw blade
Slide direction
Groove
[Model P1 and P2]
Fig. 11-b
Base surface
Workpiece
Saw blade
6 mm depth adjustment bolt
Slide direction
Groove
[Model C 8FSE/C 8FSHE]
Fig. 11-a