Filter
Top Products
15
English
Switching Device
1
Downward position
Previously pull the trigger
2
4
Push Lever
WARNING
Keep your fi nger off the trigger ●
except during nailing operation,
because serious injury could result if
the push lever accidentally contacts
you or others in work area.
Keep hands and body away from ●
the discharge area. This Hitachi
nailer may bounce from the recoil
of driving a nail and unwanted
subsequent nail may be driven,
possibly causing injury.
NOTE
If all warnings and instructions are ●
followed, safe operation is possible with
all two systems: SINGLE ACTUATION
MECHANISM and CONTACT ACTUATION
MECHANISM.
Always handle nails and package carefully. ●
If nails are dropped, collating bond may be
broken, which will cause mis-feeding and
jamming.
After nailing: ●
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic
tool lubricant into the air plug on the
Nailer; and
4) open the petcock on the air compressor
tank to drain any moisture.
Adjusting the nailing depth
WARNING
When adjusting the Adjuster, be ●
sure to remove your fi nger from the
trigger and disconnect the air hose
from the nailer.
To assure that each nail penetrates to the same
depth, be sure that:
1) the air pressure to the Nailer remains
constant (requlator is installed and working
properly), and
2) the Nailer is always held fi rmly against the
workpiece.
If nails are driven too deep or shallow into the
workpiece, adjust the nailing in the following
order.
1 DISCONNECT AIR HOSE FROM NAILER.
2 If nails are driven too deep, turn the adjuster
to the shallow side.
Adjustments are in half-turn increments.
15 Disconnect air
hose
Adjuster
If nails are driven too shallow, turn the adjuster
to the deep side.
3 Stop turning the adjuster when a suitable
position is reached for a nailing test.
4 Connect the air hose.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.