Insignia NS-32D220NA16 Work Light User Manual


 
66
Insignia 32" 720p 60Hz LED TV
www.insigniaproducts.com
General
Trouble
programming
your existing
universal
remote
control.
See instructions in “Programming
universal remote controls” on
page 32.
Codes are subject to change. For
up-to-date codes, go to
www.insigniaproducts.com/remotecodes
Replace dead batteries with new
batteries.
Refer to the User Guide that
accompanied your universal remote
control and contact the
manufacturer if problems persist.
Problem Solution
No power.
Make sure that the power
adapter is plugged into a
working outlet.
Unplug the power adapter, wait
60 seconds, then plug the
adapter back in and turn on
your TV.
Other devices (for example, a
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device, at a time, then turning
on your TV to determine which
device is causing interference.
After you have determined
which device is causing
interference, move it further
from the TV to eliminate the
interference.
“No signal”
error message is
displayed.
Press INPUT and make sure that
you have selected the correct
input for the device or service
you are trying to use.
If you are using a cable or
satellite box, use the remote
that came with that box to
change channels.
After Auto
Channel Search,
there are no
channels.
Reception can vary by channel
depending on the broadcast
power level of a given station.
Contact your cable or satellite
TV provider.
Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
Try replacing the cable between
the antenna/cable or
cable/satellite box and your TV.
Problem Solution
When I press
INPUT, I cannot
select my
device (it is
grayed out).
Turn on the device. Your TV
automatically detects and
displays which video jacks have
devices connected to them
when the devices are turned on.
Turn off Auto Input Sensing. See
Turning the input sensor on or
off” on page 59.
One or more
channels do not
display.
Make sure that the channels are
not blocked. See “Blocking
unrated TV” on page 52.
Make sure that the channels are
not hidden. The channel may
have been deleted from the
channel list. You can tune to the
channel by pressing the
number buttons or you can add
the channel back to the channel
list. See “Hiding channels” on
page 49.
If you are using a cable or
satellite box, use the remote
that came with that box to
change channels.
Press INPUT and make sure that
you have selected the correct
input for the device or service
you are trying to use.
If you are using an antenna, the
digital channel signal may be
low. To check the digital
channel signal strength, see
Checking the digital signal
strength” on page 50.
Password is lost.
•Enter 9999 to access parental
controls, then set a new
password. See “Setting or
changing the password” on
page 51.
Some settings
cannot be
accessed.
If a setting is grayed, the setting
is not available in the current
video input mode (for example
TV mode). Change to a different
video input source. See
Selecting the video input
source” on page 35.
TV cabinet
creaks.
When the TV is in use, the
temperature rises naturally and
may cause the cabinet to
expand or contract which can
cause a creaking noise. This is
not a malfunction.
Problem Solution