Filter
Top Products
22
Pulley Alignment
The pulley alignment is done in conjunction with the
poly V-belt replacement.
If you are just beginning the alignment, start with
the Replacing the Poly V-Belt section (previous
page.
If you were directed here, proceed as follows:
1. Uses a straight edge placed against the wheel
pulley and motor pulley and refer to Figure 29
to determine if alignment is necessary.
If alignment is necessary:
2. With a 4mm hex wrench, loosen two set screws
on the motor (lower) pulley.
3. Adjust the motor pulley by sliding in or out.
4. Confirm the alignment of the poly V-belt by
placing a straight edge against the faces of
both pulleys, (Figure 29). If the straight edge
lies flush against both pulleys, then the pulleys
and belt are aligned.
5. Re-tighten the two set screws on the motor
pulley.
Return to Step 7 of the Replacing Poly V-Belt
section on page 21.
Figure 29