Filter
Top Products
22
Maintenance
Before doing maintenance on
the machine, disconnect it from the electrical
supply by pulling out the plug or switching
off the main switch! Failure to comply may
cause serious injury.
Use a brush to loosen accumulated chips and
debris. Use a shop vacuum to remove the
debris. Make sure the chip brush on the lower
band wheel is properly adjusted.
Lubricate the air compressor with air tool oil
about every six months, or more frequently if
necessary. Unscrew the cap (Figure 26) and
add oil. Replace cap when finished.
Add grease to the gear box through the grease
fitting; also add grease as needed to the worm
gear.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
Figure 26
The chart (Figure 27) identifies areas that
require cleaning and/or lubricating. Use good
quality, general purpose lubricants.
Machine Part Lubricant Frequency
Bearings Machine oil Wipe down every day and
lubricate every 6 months
Rack and sliding portion of
Guide Post
Grease every 7 days
Gear shift lever Grease every 6 months
Worm gear Grease every 3 months
Variator pulley Machine oil every 3 months
Blade tension screw Grease once a month
Air compressor reservoir Air Tool oil every 6 months
Weld clamp jaws ------- clean after each use
Rubber tire ------- wipe off daily
Work tables ------- clean daily
Figure 27