Filter
Top Products
CONNECTION DIAGRAMS
F-5F-5
RANGER 300 D AND 300 DLX
14 PIN
AMPHENOL
ELECTRODE
6-20-97
K963-1 HAND AMPTROL
-OR-
S23732-9
-OR-
K814 ARC START SWITCH
K870 FOOT AMPTROL
N.B. USE POLARITY SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO A "STICK/WELD" POSITION.
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
THE ENGINE WELDER OPERATING MANUAL.
APPLICATIONS. SEE OPERATING MANUAL.
N.C. PLACE WELDER TERMINALS SWITCH TO " REMOTELY CONTROLLED" POSITION.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
N.D. PLACE OUTPUT CONTROL SWITCH IN "REMOTE CONTROL" POSITION.
N.E. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
FLOWMETER
CAUTION :
K936-1
CONTROL CABLE
RANGER 300 DLX / K930-1 TIG MODULE / CONNECTION DIAGRAM
Keep guards in place.
Keep away from moving parts.
WARNING
Only qualified personnel should install,use
or service this equipment.
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
INPUT
REGULATOR
TO GAS
FITTING
Do not touch electrically live parts.
CYLINDER
ARGON GAS
TO WORK
ELECTRODE
-OR-
6 PIN
AMPHENOL
K814 ARC START SWITCH
S23732-10
K870 FOOT AMPTROL
-OR-
K963-1 HAND AMPTROL
CRM after 9-23-97
CAUTION :
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
THE ENGINE WELDER OPERATING MANUAL.
APPLICATIONS. SEE OPERATING MANUAL.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
N.C. PLACE OUTPUT CONTROL SWITCH IN "REMOTE CONTROL" POSITION.
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
N.D. PLACE IDLER SWITCH IN "HIGH" IDLE POSITION.
N.B. USE POLARITY SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO A "STICK/WELD" POSITION.
FLOWMETER
K963-3
CONTROL CABLE
Keep guards in place.
Keep away from moving parts.
WARNING
Only qualified personnel should install,use
or service this equipment.
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
INPUT
REGULATOR
TO GAS
FITTING
Do not touch electrically live parts.
CYLINDER
ARGON GAS
TO WORK
RANGER 300 D / K930-1 TIG MODULE WITH K938-1 CONTACTOR KIT / CONNECTION DIAGRAM