Filter
Top Products
'#(.((
#, #&.,**,&'(.
• Loosen the cover retaining knob and remove the
cover.
• Remove the pre-cleaner from the paper element.
• Remove the element cover nut, element cover, and
paper element.
• Do not wash the paper element or use pressurized
air, as this will damage the element. Replace a
Dirty, bent, or damaged element with a new ele-
ment. Handle new elements carefully; do not use if
the sealing surfaces are bent or damaged.
• When servicing the air cleaner, check the air clean-
er base. Make sure it is secured and not bent or
damaged. Also check the element cover for dam-
aged or improper fit. Replace all damaged air
cleaner components.
(). Before air cleaner is reassembled make sure
rubber seal is in position around stud. Inspect, mak-
ing sure it is not damaged and seals with the element
cover.
• Reinstall the paper element, pre-cleaner, element
cover, element cover nut, and air cleaner cover.
Secure cover with the cover retaining knob.
-*,%*&/!
To ensure proper engine operation, the spark plug
must be properly gapped and free of deposits.
().:;DG:G:BDK>C<HE6G@EAJ<I=:BJ;;A:G
7:8DB:HK:GN=DI9JG>C<DE:G6I>DC6C9G:B6>CH
=DI;DG6L=>A:6;I:GHIDEE>C<I=::C<>C::86G:
;JACDIIDIDJ8=I=:BJ;;A:GL=>A:>I>H=DI
-E6G@*AJ<-:GK>8:
To ensure proper engine operation, the spark plug
must be properly gapped and free of deposits.
• Remove the spark plug cap.
• Clean any dirt from around the spark plug base.
• Use a plug wrench to remove the spark plug.
• Visually inspect the spark plug. Discard them if the
insulator is cracked or chipped. Clean the spark
plug with a wire brush if it is to be reused.
• Measure the plug gap with a feeler gauge. Correct
as necessary by bending the side electrode.
• Check that the spark plug washer is in good condi-
tion and thread the spark plug in by hand to prevent
cross-threading.
• After the spark plug is seated, tighten with a spark
plug wrench to compress the washer.
• If installing a new spark plug, tighten 1/2 turn after
the spark plug seats to compress the washer.
• If reinstalling a used spark plug, tighten 1/8 - 1/4
turn after the spark plug seats to compress the
washer.
-E6G@*AJ<!6E .030 in. (0.76 mm)-Kohler
-E6G@*AJ<.DGFJ: 20 ft. Lb. (27 N-m)-Kohler
.=:HE6G@EAJ<BJHI7:H:8JG:ANI><=I:C:9C
>BEGDE:GANI><=I:C:9HE6G@EAJ<86C7:8DB:K:GN
=DI6C9B6N86JH::C<>C:96B6<:
/H:DCANI=:G:8DBB:C9:9HE6G@EAJ<DG:FJ>K6
A:CIHE6G@EAJ<L=>8==6H6C>BEGDE:G=:6I
G6C<:B6N86JH::C<>C:96B6<:
,(!,U&*!
/.#)(
1,(#(!