Filter
Top Products
.,)/&-")).#(!
,(!,U&*!
Observe all Safety Guidelines detailed throughout this manual
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
&D86A&>C8DACJI=DG>O:9 >:A9-:GK>8: 68>A>IN for technical troubleshooting assistance before you proceed.
/.#)(
*,)&'-
-3'*.)'-
*)--#&
/-
,)''(
)/,-) .#)(
The welding arc is “cold.” The weld-
ing arc is not stable or is not satis-
factory. The engine runs normally.
The auxiliary power is normal.
1. Make sure the MODE selector
switch is in the correct position for
the process being used. (For
example, CV-WIRE, PIPE, CC-
STICK.)
2. Make sure the electrode (wire,
gas, voltage, current etc.) is cor-
rect for the process being used.
3. Check for loose or faulty connec-
tions at the weld output terminals
and welding cable connections.
4. The welding cables may be too
long or coiled, causing an exces-
sive voltage drop.
If all recommended possible areas of
misadjustment have been checked
and the problem persists, DCI68I
NDJGAD86A&>C8DACJI=DG>O:9
>:A9-:GK>8: 68>A>IN