Lincoln Electric IM528-B Welder User Manual


 
TIG MODULE
31
ACCESSORIES
OPTIONS / ACCESSORIES
The following field installed Kits and accessories may
be used dependingon the application:
K936 Control Cables
At least one of the following control cables is
needed to connect the TIG Module to the power
source. Four different cables are available. The
proper choice of cable depends on the power
source being used. See the installation section to
choose the proper control cable. The control
cable carries one or more of the following circuits
between the TIG Module and the power source:
Input power, remote control signals, contactor
control signals, and ground.
K936-1 9-Socket (at the TIG Module) to 14-pin
(at the power source) (Contains circuits
2, 4, 31, 32, 75, 76, 77 and ground)
K936-3 9-Socket to a grounded 115V plug and a
6-pin MS-connector (Contains circuits
31, 32, 75, 76, 77 and ground)
K936-4 9-Socket to a grounded 115V plug
(Contains circuits 31, 32 and ground.)
K937 Control Cables Extensions
Control cable extensions are available in 22 and
45 foot engths. These allow the TIG Module to be
operated at distances up to 200 feet from the
power source. The extensions connect between
the standard control cable and the TIG Module.
K937-22 22 foot extension cable, 9-Socket to 9-pin
K937-45 45 foot extension cable, 9-Socket to 9-pin
K938-1 Contactor Kit
This field installed kit must be installed in the TIG
Module whenever it is used with a power source
which does not have a built-in contactor for constant
current (stick/TIG) welding. See the list of compatible
power sources to see which applications require the
Contactor Kit.
K939-1 Docking Kit
The Docking Kit provides a means to dock the TIG
Module on top of a flat-roofed power source, or any
other flat surface measuring at least 10 X 15 inches
(255 X 381 mm). It includes a latch and provisions for
a user-supplied padlock to lock the TIG Module in
place.
K844-1 Water Valve Kit
A field installed kit which contains one water valve for
mounting inside the TIG Module. The water valve is
controlled by the same preflow and afterflow timers as
the gas valve.
Other Compatible Lincoln Accessories:
K963 Hand Amptrol
K870 Foot Amptrol
K814 Arc Start Switch
All Magnum TIG torches and accessories
Compatible Equipment
The TIG Module can be used with the following
Lincoln power sources:
Ranger 8
1
Ranger 9
Ranger 10
1
Ranger 10-LX
1
DC-250
DC-400
DC-600
DC-650Pro/DC-750
R3R-300/400/500,
including I versions
1
Idealarc 250 AC/DC
1
Weldanpower 150
1
Weldanpower 150 AC/DC
1
Weldanpower G8000
1
SA 250 Perkins
1
SAE 350 Deutz
1
SAE 400
1
Classic I
1,2
Classic II
1
Classic III & IIID
1
1
Requires the K938-1 Contactor Kit in the TIG Module
2
Requires a source of 115VAC power
For installation of field installed accessories see the
INSTALLATION SECTION.