Filter
Top Products
–
– 27 –
M17220
#2 HEAVY LEAD
WIREFEED
MODULE
W.F.M.
CONTROL
PANEL
NEG.
POS.
OUTPUT TERMINALS
CONNECT TO POS. & NEG.
CONNECT TO NEG.
BRUSH HOLDER
608
609
#2 HEAVY LEAD
#8 LEAD
NEGATIVE CV
OUTPUT TERMINAL
PANEL
MACHINE MUST NOT BE RUNNING
WHEN MAKING THESE CONNECTIONS.
*
INLINE
CONNECTORS
ON ENGINE WELDER REMOVE JUMPER PLUG
FROM CONNECTOR AND CONNECT W.F.M. PLUG
TO CONNECTOR ON ENGINE WELDER.
ENGINE WELDER
CONNECTOR
JUMPER PLUG
W.F.M.
PLUG
THERMOSTAT
ASSEMBLY
CAUTION:
THIS UNIT IS PREASSEMBLED WITH A 250 AMP
THERMOSTAT ASSEMBLY. INSTALLING THIS UNIT INTO A CLASSIC 1
OR ANY 200 AMP MACHINE REQUIRES REPLACEMENT OF THE 250
AMP THERMOSTAT AS'BLY WITH THE 200 AMP THERMOSTAT AS'BLY
PROVIDED IN THE MOUNTING HARDWARE PACKET.
WIRE FEED MODULE / ENGINE WELDER CONNECTION DIAGRAM
3-18-94
M17220
#2 HEAVY LEAD
WIRE FEED
MODULE
W.F.M.
CONTROL
PANEL
NEG.
POS.
OUTPUT TERMINALS
CONNECT TO POS. & NEG.
CONNECT TO NEG.
BRUSH HOLDER
608
609
#2 HEAVY LEAD
#8 LEAD
NEGATIVE CV
OUTPUT TERMINAL
PANEL
MACHINE MUST NOT BE RUNNING
WHEN MAKING THESE CONNECTIONS.
*
INLINE
CONNECTORS
ON ENGINE WELDER REMOVE JUMPER PLUG
FROM CONNECTOR AND CONNECT W.F.M. PLUG
TO CONNECTOR ON ENGINE WELDER.
ENGINE WELDER
CONNECTOR
JUMPER PLUG
W.F.M.
PLUG
THERMOSTAT
ASSEMBLY
CAUTION:
THIS UNIT IS PREASSEMBLED WITH A 250 AMP
THERMOSTAT ASSEMBLY. INSTALLING THIS UNIT INTO A CLASSIC 1
OR ANY 200 AMP MACHINE REQUIRES REPLACEMENT OF THE 250
AMP THERMOSTAT AS'BLY WITH THE 200 AMP THERMOSTAT AS'BLY
PROVIDED IN THE MOUNTING HARDWARE PACKET.
WIRE FEED MODULE / ENGINE WELDER CONNECTION DIAGRAM
3-18-94
NOTE: This diagram is for reference only. It may not be accurate for all machines covered by this manual. The specific diagram for a particular code is pasted inside the
machine on one of the enclosure panels. If the diagram is illegible, write to the Service Department for a replacement. Give the equipment code number.