Filter
Top Products
F-82
TROUBLESHOOTING & REPAIR
F-82
MOTOR REMOVAL
PROCEDURE
1. Remove input power to the NA-5.
2. Remove the motor and tach cable
from the NA-5 control box.
3. Perform the
Tach Board Removal
Procedure
.
4. Using the slot head screwdriver
remove the two screws mounting the
tach housing to the drive motor.
Remove the tach housing from the
drive motor.
5. Using the phillips head screwdriver
remove the cover plate adaptor.
See Figure F.16
6. Using the 5/16" nutdriver remove the
clamp holding the connection box to
the drive motor.
7. Carefully remove the connection box
being careful not to stretch the leads.
WIRE DRIVE MOTOR REMOVAL AND REPLACEMENT (Continued)
NA-5
FIGURE F.16 DRIVE MOTOR AND TACH HOUSING
WIRE
DRIVE
MOTOR
TACH HOUSING
COVER PLATE
ADAPTER
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC