Filter
Top Products
TROUBLESHOOTING & REPAIR
F-64 F-64
PRO-CUT 55
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
FIGURE F.24 – POWER BOARD HEATSINK AND CAPACITOR REMOVAL
CAPACITOR
CLAMP
3/8" MOUNTING
INSULATOR (2)
MOUNTING
SCREW (2)
SOCKET
HEAD
SCREW (4)
7/16"
CAPACITOR
BOLT (4)
PRIMARY
POWER
P.C. BOARD
PRIMARY POWER BOARD AND FILTER CAPACITOR
REMOVAL AND REPLACEMENT (continued)
7. Using the slot-head screw driver, remove the
two mounting screws from the left side of the
primary power board. See Figure F.24. Take
note of insulator placement for reassembly.
8. Using the 3/16” allen type wrench, remove
the four socket head screws and lock wash-
ers mounting the primary power board to the
heat sink.
9. Carefully remove the primary power board
from the heat sink.
Be sure to follow the recommended static-free
methods for handling printed circuit boards.
Failure to do so can result in permanent damage
to the equipment.
CAUTION