Filter
Top Products
To prevent the switch trigger from being
accidentally pulled,
a
lock-off button is pro-
vided. To start the tool, press in the lock-off
button and pull the switch trigger. Release
the switch trigger to stop.
Loc
k-of
f
but
ton
I
Operation
CAUTION:
*Before use, be sure to release the handle from the lowered position by pulling the stop-
per pin.
*Make sure the blade is not contacting the workpiece, etc. before the switch is turned on.
*Do
not apply excessive pressure on the handle when cutting.
Too
much force may result
in overload of the motor and/or decreased cutting efficiency.
*Gently press down the handle to perform the cut. If the handle is pressed down with
force or if lateral force is applied, the blade will vibrate and leave
a
mark (saw mark) in the
workpiece and the precision of the cut will be impaired.
*During
a
slide cut, gently push the carriage toward the guide fence without stopping. If
the carriage movement
is
stopped during the cut,
a
mark will be left in the workpiece and
the precision
of
the cut will be impaired.
1.
Press cutting (cutting small workpieces)
*Workpieces up to
61
mm (2-3/8") high and 122 mm
(4-1
3/16") wide can be cut in the
following way.
*Push the carriage toward the guide
fence fully and tighten the clamp
screw to secure the carriage. Secure
the workpiece with the vise. Switch on
the tool and wait until the blade attains
full speed before lowering gently into
the cut. When the cut is completed,
switch off the tool and WAIT
UNTIL
PLETE STOP before returning the
blade to its fully elevated position.
THE BLADE HAS COME
TO
A COM-
CAUTION:
Firmly tighten the clamp screw
so
that the carriage will not move during operation.
Insufficient tightening may cause unexpected kickback of the blade. Possible serious
injury may result.
18